Tilta WLC-T06-P7p-70 Nucleus-M II P-TAP To 7-PIN Power Cable 70cm

Tilta WLC-T06-P7p-70 Nucleus-M II P-TAP To 7-PIN Power Cable 70cm | A direct power link, 70cm long

Connect a P-TAP power source to the 7-pin connection for a Nucleus-M II setup with this 70cm cable. The Tilta WLC-T06-P7p-70 Nucleus-M II P-TAP To 7-PIN Power Cable gives you a defined cable length to work with when placing the power source and the Nucleus-M II connection in relation to each other. It’s a specific cable for that connection, rather than a general-purpose lead. That makes it a straightforward option when your setup calls for P-TAP at one end and 7-pin at the other. The 70cm length is the practical detail to consider: it gives you a fixed run to plan around, so it’s worth picturing where both ends need to reach before you set up. For a rig where that route suits, the job is simple—make the stated power connection without needing a longer cable.

Planning the cable run

A cable’s length matters once power and the connected equipment are in position. At 70cm, this lead is best considered as a short, defined connection: allow for the route between the P-TAP source and the 7-pin connection, rather than measuring only the straight-line gap. If the cable has to follow a particular path around a rig, that path uses some of its available length. This is a small but useful point to settle while planning your setup. The cable is identified for Nucleus-M II and has the connector types named in its title; match those details to the connection you need. When the distance works, you have a clear, direct cable choice for the specified power link.

Technical Specifications

• Product: Tilta WLC-T06-P7p-70 Nucleus-M II P-TAP To 7-PIN Power Cable
• Power connection: P-TAP to 7-PIN
• Named system: Nucleus-M II
• Cable length: 70cm