Nedis Fiber Optic SMF (Single Mode Phase) SC/Apc SC/Apc 100 Gbps 2m

Nedis Fiber Optic SMF (Single Mode Phase) SC/Apc SC/Apc 100 Gbps 2m | A short fibre link for high-capacity connections

A direct fibre connection is easier to plan when the cable length and ends are clear. This Nedis cable is a 2m single-mode fibre optic lead, with an SC/APC connector at each end and a stated capacity of 100 Gbps. It suits a short link between equipment that takes those matching connections, where a fibre cable is required. The useful detail here is the combination of connector type, fibre mode and length: you can compare those with the needs of your setup before routing the cable. Its two-metre reach keeps it to a compact run rather than a long installation. One practical point: the SC/APC ends need matching ports, so the connector detail matters as much as the headline data rate. If those requirements line up, this cable gives you a straightforward way to join the two points.

Choosing the right link

When planning a fibre connection, start with the ports at both ends, then consider the link’s required capacity and the route the cable will take. Connector names can look similar at a glance, but they describe a particular connection; matching them avoids choosing a lead that won’t fit the intended ports. Fibre mode is another key part of the match, so the single-mode designation is relevant when selecting a cable for an existing link. The stated 100 Gbps figure gives you a clear capacity reference for comparing it with your equipment or network requirements. And because this is a short cable, it makes most sense where the two connection points are close together. There’s no need to treat it as a general-purpose cable: it’s a specific fibre link, with its connection type and mode named right in the product details.

Technical Specifications

• Brand: Nedis
• Type: Fibre optic cable
• Fibre mode: Single mode (SMF)
• Connectors: SC/APC to SC/APC
• Data rate: 100 Gbps
• Length: 2m