Nedis Antenna Cable SMA M SMA F Gold Plated 50 Ohm Single Shielded 5.00m

Nedis Antenna Cable SMA M SMA F Gold Plated 50 Ohm Single Shielded 5.00m | A five-metre cable with defined SMA ends

Without a cable with the right connector ends, joining an antenna connection to another point can turn into a search for the correct lead. This Nedis antenna cable has an SMA male connector at one end and an SMA female connector at the other, for setups that call for that specific pairing. It’s five metres long, so you can allow for the route between the two connection points when choosing a cable. The stated impedance is 50 Ohm, and it’s single shielded with gold-plated connectors. Those details make it easier to compare the cable with the requirements of the equipment you’re connecting, rather than relying on appearance alone. It suits anyone who needs this connector combination and cable type; the key is that the connectors and impedance match the intended connection. A cable’s length can help with routing, but it can’t make a different connector fit.

Matching the cable to your setup

Start by identifying the connector required at each end of the antenna connection. This cable’s male-to-female SMA arrangement is specific, so compare both ends rather than looking only for “SMA” in a product description. Then consider the route the cable needs to take: the 5.00m length is the figure to use when judging whether it can reach between your connection points. Finally, match the stated 50 Ohm impedance to the requirement for your setup. These are simple checks, but they help narrow the choice to a cable with the right ends, length and stated impedance. If those details are what you need, this listing gives you a clear basis for comparison.

Technical Specifications

• Product type: Antenna cable
• Connector ends: SMA male and SMA female
• Connector finish: Gold plated
• Impedance: 50 Ohm
• Shielding: Single shielded
• Length: 5.00m