ACT Cable Tie Mount Adhesive Maximium Width 4.60mm

ACT Cable Tie Mount Adhesive Maximum Width 4.60mm | Keep a cable in place

Keep a cable where you’ve routed it instead of letting it wander across your work area. The ACT Cable Tie Mount is an adhesive mount for use with a cable tie, and it accepts ties up to 4.60 mm wide. That maximum gives you a clear sizing point when you’re choosing a tie for a cable-management job: the tie needs to be no wider than the stated limit. It suits anyone who wants to secure a cable along a planned route, whether that’s around a desk or another equipment area. The purpose is simple: use the mount as an anchor for a tie, then use the tie to hold the cable in position. It’s a general cable accessory, rather than something tied to a particular camera system. The useful detail to check is the tie width; a tie wider than 4.60 mm exceeds the mount’s stated capacity.

When choosing this mount, start with the cable tie you intend to use. Its width is the deciding measurement given in the product name, so compare that figure with the 4.60 mm limit before setting up your cable route. A tie at or below that width fits the stated maximum; a wider one does not. This keeps the choice practical and clear, without relying on assumptions about the cable, the mounting location or the equipment around it. The product’s two defining points are its adhesive mounting and its maximum supported tie width. If those match the job you have in mind, the ACT mount provides a straightforward way to anchor a cable tie and keep a cable positioned along your chosen route. That’s the specific task this accessory is described for.

Technical Specifications

• Brand: ACT
• Product type: Adhesive cable tie mount
• Maximum cable tie width: 4.60 mm