Nedis DMX-Cable 110 Ohm 2X 0.23MM² 100m Rol Grey

Nedis DMX-Cable 110 Ohm 2X 0.23MM² 100m Rol Grey | Bulk length for planned DMX cable runs

The defining decision here is the 100m roll: it gives an installer a long supply of DMX cable to plan around, rather than a single pre-set lead. Nedis specifies a 110 Ohm cable with two 0.23 mm² conductors, in grey. It’s suited to people building or maintaining DMX cable runs who want to plan the route and working length for their setup. The roll format is especially practical when a job calls for more than one run or a non-standard span; you can plan the amount against the actual path instead of starting with a short, fixed cable. Grey is a straightforward, low-key finish in a lighting installation. One honest point: 100 metres is a substantial length, so it makes most sense when you have a project to use it on, rather than needing one short connection.

Planning a cable run

This is a bulk format, so think in terms of installation work rather than a ready-made patch lead. Map the intended cable route and decide where each run begins and ends before you measure out what you need. Allow for the path the cable will actually take; a direct line on a floor plan can differ from a route around a room or equipment. Where the cable will be visible, its grey colour gives the installation a neutral appearance. It won’t identify individual circuits by itself, so labelling completed runs is a sensible part of the job. These are simple planning steps, but they matter when working with a long roll. If your requirement is just one short connection, this format may be more cable than you need.

Technical Specifications

• Brand: Nedis
• Product type: DMX cable
• Impedance: 110 Ohm
• Conductors: 2 × 0.23 mm²
• Length: 100 m
• Format: Roll
• Colour: Grey